Art Care
How to Flatten a Rolled Print: Reverse Roll, Then 24 Hours
To flatten a rolled print, reverse-roll it image side out around the tube for about an hour, then lay it face up between sheets of acid-free tissue, glassine or blotter under a flat board with even weight for 24 hours or longer. Do not unroll brittle paper when the room is below 35% relative humidity, and leave humidifying a valuable print to a paper conservator.
By Travis Moher · Published November 17, 2026
Almost every print that arrives at a gallery by mail arrives in a tube. Most will lie flat with patience and nothing more than a clean table and some weight. A few should never be forced: old, brittle, or valuable prints, and anything drawn in pastel or charcoal. The difference between those two groups is the most important thing on this page.
The 35% rule: check the paper before you unroll
Never try to open a rolled print of uncertain condition when the air is very dry, below about 35% relative humidity. That is the National Park Service's warning in its guidance on flattening rolled paper, because paper “remembers” a roll and can crack if forced open when it is dry and brittle. Before unrolling, look at the outer edge. If it is stiff, flaking, cracked, or tears when you ease it back an inch, stop. That print needs controlled humidification, not muscle.
Ease the print out of the tube by tipping it, not by reaching in and pulling. Pinching a roll from inside the tube is how prints pick up creases before you have even started.
Method by print type
| Method | Time | |
|---|---|---|
| Offset or digital poster | Reverse roll, then weight between clean sheets | About 1 hour rolled, then 24 hours flat |
| Giclée on fine art paper | Gentle reverse roll on a wide tube (10 cm / 4 in or more), then weight | 24 hours flat, longer for heavy rag papers |
| Photograph | Weight the borders only; nothing on the image surface | Overnight or longer |
| Pastel, charcoal, chalk | Do not weight the face or reverse roll; frame or consult a conservator | Not a home job |
| Watercolor, gouache, soluble inks | Weighting only; never humidify | 24 hours or longer |
| Brittle, old, or valuable print | Do not force it open; paper conservator humidifies and flattens | Hours to days, done in stages |
Times: poster printer guidance (1 hour reverse rolled, 24 hours weighted) and National Park Service flattening guidance (overnight to several days under weight after humidification). Tube diameter from Gaylord's rolled-storage guidance. Heavier papers and tighter rolls take longer.
Step 1: reverse roll
Lay the print face down on a clean surface and roll it the opposite way around the tube, so the image faces out. Secure it loosely with a paper band and leave it about an hour, which is the time one large poster printer gives for this step. Use a wide tube; Gaylord recommends archival tubes at least 4 inches (10 cm) in diameter for rolled paper, and a wider roll is gentler on heavy fine art paper. Put a sheet of acid-free tissue between the print face and itself so the image does not rub as it rolls.
Step 2: weight it flat
Unroll the print face up on a clean, smooth, flat table. Distortions in the surface transfer to damp or stressed paper, so the table matters. Cover the print with acid-free tissue, glassine, or a clean blotter, then put a rigid flat board on top and add weight evenly across it. The National Park Service's flattening guidance uses a sheet of 1/2 inch (1.3 cm) acrylic with smoothed edges, or 1/4 inch (6 mm) plate glass or a smooth board with books added on top. Leave it 24 hours, the time the poster printer gives for this step, and longer for heavy papers. If the curl comes back, reverse roll and weight again.
Avoid weights on the four corners only. That holds the corners and lets the center keep its wave, and it dents soft paper. A board spreads the load.
Humidification: where DIY ends
Professional flattening uses moisture. The National Park Service guidance explains that controlled, short-term exposure to 65% to 100% relative humidity relaxes paper, that most papers relax in 4 to 6 hours in a humidity chamber, and that the paper then dries between blotters under weight overnight or for several days. It is also full of warnings: never humidify water-soluble media such as watercolor and some inks, friable media such as pastel and charcoal, or parchment; never leave paper in the chamber unsupervised; and if paper is still resistant after three attempts, consult a paper conservator. Most importantly, it says works of high artistic or associative value should be discussed with a conservator before any treatment.
The Northeast Document Conservation Center is firmer still: its treatment leaflet presents humidifying and flattening as conservator procedures, not to be attempted without a conservator's supervision. The Library of Congress points readers to the American Institute for Conservation directory to find one. Our position as a gallery: for a signed edition, an original, or anything you would insure, the conservator's fee is small next to the cost of a cockled or torn sheet. Steam from a kettle, a damp towel, and an iron are all ways people ruin prints.
Free to use
Put this flattening chart on your site
Sell prints or posters that ship in tubes? Embed our flattening chart for your customers. Copy the snippet below; it renders a clean table anywhere. The only ask: keep the small credit link to Austin Gallery.
Click inside the box, select all (Cmd-A or Ctrl-A), and copy. Includes one credit link back to this page.
Exceptions and distinctions
- •Photographs. Keep weight off the emulsion. The National Park Service guidance weights only the borders of a photograph as it dries.
- •Pastel and charcoal. Anything pressed against the surface lifts powdery media. Do not cover, weight, or reverse roll; have it framed with a spacer or see a conservator.
- •Heavy screenprints and coated papers. Thick ink layers and coatings can crack if reverse rolled too tightly. Use the widest tube you have, or skip straight to weighting.
- •Ironing. Some poster printers describe ironing a cheap poster on low heat through a damp cloth, and also warn it can shift the ink colors. It has no place near an art print.
- •A slight wave is normal. NEDCC notes that paper naturally undulates with humidity even after treatment. Hinged in a mat, a print with a gentle wave will usually relax in the frame. The Canadian Conservation Institute recommends just two T-shaped hinges at the top for small to medium works, which lets the paper move.
- •Do not tape it flat. Tape on the face or edges stains and tears paper. Weight it, then hinge it properly when framing.
Once it is flat, keep it that way. Store prints flat in folders or boxes rather than back in the tube; our guide to storing art covers flat storage, and our art humidity and temperature guide explains why a stable room is what keeps paper from curling again. Shipping one onward? See how to pack and ship art.
Frequently asked questions
How do you flatten a print that has been rolled?
Reverse-roll it: lay it face down, roll it the opposite way around the tube so the image faces out, and leave it about an hour. Then lay it face up on a clean flat table between sheets of acid-free tissue, glassine or blotter, put a flat board on top with even weight, and leave it for 24 hours. Repeat if the curl returns.
How long does it take to flatten a rolled poster?
About an hour reverse-rolled plus 24 hours under weight for a typical poster. Heavy fine art papers that spent months in a tube can take several days under weight. After professional humidification, conservators leave paper under weight overnight or for several days.
Can you iron a rolled print to flatten it?
Not an art print. Some poster printers describe ironing a cheap poster on the lowest setting through a damp cloth, but they also warn it can change the ink colors. For a giclée, lithograph, screenprint or photograph, use reverse rolling and weighting instead.
Is it safe to humidify a print to flatten it?
For valuable works, have a paper conservator do it. The National Park Service guidance says controlled short exposure to 65% to 100% relative humidity will relax paper, usually in 4 to 6 hours, but warns never to humidify water-soluble media, pastels or charcoal, and to discuss works of high artistic value with a conservator before any treatment.
Why will my print not stay flat?
Paper keeps the memory of a tight roll, and it responds to humidity. Weight it longer, frame it soon after flattening, and keep it in a stable room. Even conserved paper naturally undulates a little as humidity changes, so a slight wave inside a mat is normal.
What weight should I use to flatten a print?
Even weight across the whole sheet matters more than heavy weight. Use a flat board, a sheet of 1/2 inch (1.3 cm) acrylic, or 1/4 inch (6 mm) glass with smoothed edges on top, then add books evenly. Do not put weights only on the corners of an art print.
Should I unroll an old print myself?
Not if it feels stiff, cracks at the edge, or the room is very dry. National Park Service guidance says never to open a rolled paper of uncertain condition, especially when relative humidity is below 35%. A brittle roll needs controlled humidification by a conservator.
Sources
- National Park Service, Conserve O Gram 13/2: How to Flatten Folded or Rolled Paper Documents
- Northeast Document Conservation Center: Conservation Treatment for Works of Art and Unbound Artifacts on Paper
- Canadian Conservation Institute: Basic care, works of art on paper
- Library of Congress: Care, Handling, and Storage of Works on Paper
- Gaylord Archival: Preserving Oversize Documents
- instantprint: How to Flatten a Rolled Poster
Austin Gallery's care notes are general guidance, not conservation treatment advice. For a valuable, brittle, or irreplaceable print, consult a professional paper conservator.
More gallery reference guides
Cite this guide
Writers, framers, designers and students are welcome to quote this page. If you use one number, use this one:
Reverse-roll a rolled print for about an hour, then weight it flat under a board for 24 hours; never unroll brittle paper below 35% relative humidity, and leave humidifying valuable prints to a paper conservator.
Suggested citation:
Austin Gallery, "How to Flatten a Rolled Print: Reverse Roll, Then 24 Hours," updated November 2026. https://www.austingallery.org/blog/how-to-flatten-a-rolled-print
More free charts: the Austin Gallery reference library.